Operation; Roller/Extension Bars Adjustment; To Raise And Lower The Stand - PowerTec MT4005 Owner's Manual

4
WARNING
Do not use the miter saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 440 lbs (200 kg). Power tools
on the miter saw stand should not exceed a combined
overall height of 60" (1.5 m) from the floor.
4

ROLLER/EXTENSION BARS ADJUSTMENT

Refer to Figure 10
The extension bars move in and out to the properly
support the workpiece.
The roller bars are used as directional rollers or with the
extension bars as stationary stop guides.
• Loosen the extension bar locking knobs, slide the
extension bar in or out to the required position, tighten
the extension bar locking knobs.
• Loosen the roller bar locking knobs, slide the roller bars
up and down to desired location, tighten the roller bar
locking knobs.
Figure 10
Roller Bar
Locking
Knob
Extension Bar Locking Knobs
Extension
Bar
Roller
Bar

OPERATION

TO RAISE AND LOWER THE STAND

Refer to Figure 11
The stand has three positions.
Position 1: Work Height (82 cm)
Position 2: Work Height (68.5 cm)
Position 3: Storage/Transport Position
Figure 11
• Loosen the locking knobs on the adjusting brackets,
both sides.
• Place one foot on the leg extension to hold the stand
in place.
To raise
• Depress the release lever, lift and slightly pull the
table top towards you and raise the table top.
To lower
• Lift and slightly push the table top away from you and
lower the table top.
• Position the locking knob into one of the three position
and tighten on each side.
Handle
Locking Knob
Depress
Release
Lever