Assembly; Unpacking; Tools Needed - PowerTec MT4000 Owner's Manual

2

UNPACKING

Refer to Figure 1
Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION
A Miter Saw Stand
B Quick Release Mounting Brackets
2
C Roller Bars
D Large Locking Knobs (roller bars)
E Small Locking Knobs (extension bar)
F Wheels
G Retaining Rings (wheels)
H Handle
I Bolt (handle)
J Flat Washer (handle)
K Lock Washer (handle)
L Nut (handle)
M Axle Plate/Socket Case Assembly with
hardware
N Pig Tail Cord
O Miter Saw Mounting Hardware
(mounting bolt, washer, lock washers
and nut)
Figure 1
A
B
F
C
D
WARNING
Do not use the miter saw stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this miter saw stand.
WARNING
Do not use the miter saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 330 lbs (150 kg). Power tools
on the miter saw stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.

ASSEMBLY

QTY
1
2
2
2
4
2
2
1
2
2
2
2
1
1
4
H
M
N
O
G I
L
K
J
E

TOOLS NEEDED

The following tools (not included) are needed to assemble
the miter saw stand:
Adjustable pliers
#6 Hex wrench
#13 Open end wrenches
ASSEMBLE AXLE PLATE/SOCKET CASE
AND WHEELS
Refer to Figure 2
• Remove nuts, washers and lockwashers from axle
plate/socket case assembly.
• Place the axle plate/socket case assembly onto the
miter saw stand as shown and secure in place with
hardware removed earlier.
Figure 2
Bolt
Refer to Figure 3
• Slide the wheel onto the axle and secure in place with
the retaining ring. Repeat with other wheel.
NOTE: Raised hub goes to the inside.
Figure 3
Axle
Lock Washer
Nut
Flat Washer
Axle Plate/
Socket Case
Assembly
Wheel
Retaining
Ring