Fluke IDA-5 Getting Started page 13

•
The Product must be properly earthed.
Only use a supply socket that has a
protective earth contact. If there is any
doubt as to the effectiveness of the
supply socket earth, do not connect the
Product. Do not use a two-conductor
adapter or extension cord. This will
break the protective ground connection.
•
Many components on the printed circuit
board are static sensitive. ESD
precautions should be observed when
handling the printed circuit board
assembly.
•
To avoid shock hazard and for proper
Product operation, connect the factory
supplied three-conductor line power
cord to a properly grounded power
outlet. Do not use a two-conductor
adapter or extension cord; this will break
the protective ground connection.
•
The Product is intended for use by
trained service technicians to perform
periodic inspections on a wide range of
medical equipment. The testing
procedures are menu-driven, and simple
to operate.
Infusion Device Analyzer
•
The Product is intended for use with
single-phase, grounded power. It is not
intended for dual, split-phase or three-
phase power configurations. But it can
be used with any power system that
supplies the correct voltages for single-
phase and is grounded.
•
This Product is intended to be used in
the laboratory environment, outside of
the patient care area, and is not intended
for use on patients, or to test devices
while connected to patients. This
Product is not intended to be used to
calibrate medical equipment and not
intended for over the counter use.
Safety Information
3