Installation - Husqvarna AUTOMOWER 550H Operator's Manual

Note: If the mowing results are not
satisfying, the cutting time can be adjusted
to mow for a longer time
(Low)
shorter time
3.15.2 ECO mode
The ECO mode function automatically turns off
the signal in the boundary loop, the guide wires
and the charging station when the product is not
mowing. ECO mode is suitable to use where
there is other wireless equipment not compatible
with the product, for example some hearing loops
or garage doors. When ECO mode is activated,
the indicator lamp in the charging station flashes
green.
ECO mode means that the product can only be
started in the charging station and not out in the
work area. In ECO mode, it is therefore very
important to always press the STOP button on
top of the product, before removing the product
from the charging station. It is otherwise not
possible to start the product inside the work area.
If the lawnmower has been removed by mistake
without first pressing the STOP button, the
lawnmower must be placed back in the charging
station and the STOP button pressed. Then
press the START button to be able to start inside
the work area.
Note: In ECO mode, always press the STOP
button before removing the product from the
charging station.
1. Tap the On/Off bar to enable/disable ECO
mode.
3.15.3 Spiral cutting
If the product enters an area where it senses the
grass is longer than average, it can change the
movement pattern to spiral cutting. This means
that the product mows in a spiral pattern to faster
cut the area with longer grass. It is possible to set
the intensity of the spiral cutting.
intensity means that spiral cutting begins less
High / Very high intensity means that spiral
often.
cutting begins more often.
Note: In order to minimize the risk for lawn wear
in steep slopes, spiral cutting does not start in
slopes steeper than 15%.

24 - Installation

(High) or for a
1.
2.
3.16 Installation
3.16.1 Methods for the product to find the
charging station
The product has 3 search methods to find the
charging station:
•
•
•
The factory setting is set to mix the 3 search
methods. When the battery is low the product
Very low / Low
starts to search for the charging station with the
irregular method for 3 min. After 3 min the
product changes search method to the guide wire
method. The product tries to find the guide wire
for 8 min. After 11 min the product changes
search method to the boundary wire method.
Tap the On/Off bar to enable/disable
cutting .
The intensity can be adjusted to trigger on a
shorter or longer grass length. Choose an
appropriate intensity level by tapping on
Very low, Low, Medium, High or Very high .
In the Installation menu it is possible to
adapt the settings of the product for
best mowing result.
Charging station signal - The product moves
in the work area until it finds the signal of the
charging station.
Guide wire - The product moves in the work
area until it finds the guide wire. The product
moves along the guide wire to the charging
station.
Boundary wire - The product moves in the
work area until it finds the boundary wire.
The product moves along the boundary wire
to the charging station.
Spiral
1102 - 002 -