Accessories - Husqvarna AUTOMOWER 550H Operator's Manual

find the charging station. When the product
moves in the direction of the charging station, it
always moves to the left of the boundary wire.
The boundary corridor width is specified in
intervals from 1-9. The first number in the interval
specifies the shortest distance to the boundary
loop and the second number the longest
distance. The distance the product maintains
from the boundary loop varies depending on the
layout of the work area. The default setting is 3-6.
1. Slide the horizontal bar to specify the
required interval.
3.16.4.2 To set the corridor width of the guide
wire
The guide corridor is the area adjacent to the
guide wire, which the product uses to find the
charging station. When the product moves in the
direction of the charging station, it always moves
to the left of the guide wire.
The guide corridor width is adjusted
automatically. Only in rare occasions manual
settings need to be entered. The guide corridor
width can be set between 0 and 9. If guide
corridor width is set to 0, the product straddles
the guide wire. This means that the product runs
right over the guide wire. The default setting is 9.
1. Slide the horizontal bar to specify the
required value.
Note: Make the corridor width as wide as
possible for a minimum risk of lines in the lawn.
3.16.5 Exit angles
Normally the product leaves the charging station
in a direction within the 90°-270° exit sector. By
changing the exit angles, it makes it easier for the
product to reach the work areas.
26 - Installation
3.16.5.1 Exit angles > Sectors
The product can be set for 1 or 2 exit sectors. If
the charging station is placed in a passage, 2 exit
angles, for instance 70° - 110° and 250° - 290°,
can be used.
When 2 exit angles are used, there is a need to
also specify how often the product must leave the
charging station in Sector 1 . This is done using
Proportion function by initially specifying a
the
percentage.
For instance the percentage of 75 % means that
the product leaves the charging station in
1 on 75% of the times and 25% of the times in
Sector 2 .
1. Slide the horizontal bar to specify the
required angles in degrees for the sectors,
and proportion as a percentage.
3.16.6 To set the reversing distance
The reversing distance makes the product move
in reverse for a set amount of cm before the
product starts to cut the lawn. The default setting
is 60 cm.
1. Slide the horizontal bar to specify the
required reversing distance.
3.16.7 To set the Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting is 31 cm. You can select a
distance of 20 cm and 50 cm.
1. Slide the horizontal bar to specify how much
the product should pass the boundary wire.

3.17 Accessories

Settings for accessories mounted on
the product can be made in this menu.
3.17.1 Mower house
When this option is enabled, the wear on the
product and the house is reduced, but it can
result in more uncut grass around the charging
station.
Sector
1102 - 002 -