Husqvarna AUTOMOWER 550H Operator's Manual page 14

CAUTION: Do not lift the product when
it is parked in the charging station. It
can damage the charging station
and/or the product. Press STOP and
pull theproduct out of the charging
station before lifting it.
2.3.4 Maintenance
WARNING: When the product is
turned upside down the main switch
must always be in the
The main switch should be set in the
position before all work on the chassis
of the product, such as cleaning or
replacing the blades.
CAUTION: Never use a high-pressure
washer or even running water to clean
the product. Never use solvents for
cleaning.
CAUTION: Use the plug to disconnect
the charging station before any
cleaning or maintenance of the
charging station or the loop wire.
14 - Safety
Inspect the product each week and replace any
damaged or worn parts. Refer to
page 33 .
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical
components in the product and the charging
station, we recommend that all connections to the
charging station are disconnected (power supply,
boundary wire and guide wire) if there is a risk of
a thunderstorm.
0 position.
1.
0
2.
3.
Mark the wires to simplify reconnecting. The
charging station's connections are marked
AR, AL and G1. Some models have
additional guide wires (G2, G3).
Disconnect all connected wires and the
power supply.
Connect all the wires and the power supply
if there is no longer a risk of thunder. It is
important that each wire is connected to the
right place.
Maintenance on
1102 - 002 -