Symbols On The Product - Husqvarna AUTOMOWER 550H Operator's Manual

24. Operator's manual and Quick Guide
25. Couplers for loop wire
26. Loop wire for boundary loop and guide wire
3
4
27. Stakes
28. Connector for the loop wire

1.4 Symbols on the product

These symbols can be found on the product.
Study them carefully.
2
Is a part of the Installation kit which is purchased separately.
3
See note 2
4
See note 2
5
See note 2
1102 - 002 -
2
5
WARNING: Read the
user instructions before
operating the product.
WARNING: Operate the
disabling device before
working on or lifting the
machine.
The product can only start
when the correct PIN
code has been entered.
Switch off the product be-
fore carrying out any in-
spections and/or mainte-
nance.
WARNING: Keep a safe
distance from the ma-
chine when operating.
Keep your hands and feet
away from the rotating
blades.
WARNING: Do not ride
on the machine. Never
put your hands or feet
close to or under the ma-
chine.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 50 and on the
rating plate.
Introduction - 5