Klarstein 10030663 Manual page 31

3. Deckel schließen. Die Schritte 6-12 wie bei dem universalen Fass durchführen. Schritt 9 weicht allerdings
ab.
Change a new beer keg (5 litre universal keg)
When the beer in the keg runs out, before changing a new beer keg:
1. Adjust the CO pressure regulation knob to "-" switch to shut off the CO
2
2. Open the top cover of the beer cooler, pull down the tap handle to release the rest gas in the keg (maybe
with some beer bubble).
3. Then put the piercing pin into the new keg and put into the beer cooler. Connect the gas-tube and beer
tube from the keg lifter, by pressing the white parts of keg lifter.
4. Disconnect the gas-tube and beer tube from the keg lifter,
5. Take out the keg by the keg lifter, and pull out the piercing pin from the keg.
6. It is recommended to clean the tap mechanism when changing the beer keg each time. Please refer to
the below contents about cleaning.
When you take out the fastener of beer
dispensing unit, you can move this unit to-
wards arrow indication.
When you take out the beer connector and CO
connector, please press the white button down.
31
2
supplying and save the CO
2
You must take out
the right fastener at
first, then push the
left fastener out as
arrow indication,
you can pull out
the dispensing unit
finally.
.
2