Klarstein 10030663 Manual page 28

4. Loosen the CO bottle sheath (Show as figure 15), insert a 16gram CO
2
the sheath tightly until you will hear a "Click"(Figure 17), which indicates that the cartridge seal has been
pierced and the CO
2
the CO leakage. Then put CO
2
Regualtor
assembly
5. Close the top cover of the beer cooler; When pouring out the beer, the turn the knob on the top cover to
"+" position to release the CO2, and turn it to "-"position when pause or stop pouring beer to close the
CO2. Please refer to the notice label on the top cover.
6. Turn on the power switch to "I" position to power on the beer cooler. (While "0"position is to power it off)
NOTE: Please make sure your hands are dry when you operate the beer cooler, to avoid electric
shock.
7. It will take 19-21 hours to cool the beer to 0-4 °C at 22-24 °C ambient temperature. And it can keep the
temperature as set and displayed on the LED. (The LED will display the real temperature of the beer). We
gas can flow into the keg freely. Make us the bottle sheath is fixed tightly to avoid
bottle sheath into the top cover.
2
cartridge in the sheath), and screw
2
16 g CO
2
Note:
• Turn off the CO knob when cooling the
2
beer.
• Turn off when the beer flow is paused.
• Turn off when changing the CO
• If the beer cannot be tapped out (there is
still beer in the keg), or beer foams are not
enough, turn the knob to „+" position for 5
seconds then turn it off again.
16 g CO bottle
2
sheath
cartridge.
2
28