Klarstein 10030663 Manual page 29

do, however, suggest that you initially cool your beer keg for at least 12 hours in your refrigerator before
placing it into the beer cooler, especially when the ambient temperature is higher than 25 °C.
8. The beer cooler has 6 preset temperatures.
Press and hold "-" button, it enter the 6 preset temperatures, then you can press "-" button to choose a
certain preset temperature, 12 °C, 10 °C, 8 °C, 6 °C, 4 °C and 2 °C.
Press and hold "+" button, it enter the 6 preset temperatures, then
you can press "+" button to choose a certain preset temperature, 2 °C, 4 °C, 6 °C, 8
°C, 10 °C and 12 °C.
The PCB has the memory function, when you power on the cooler, it memories the
set temperate of last time.
The LED will default display the real temperature of beer. You can see the set tem-
perature by pressing "+" button 1 second, it will display the set temperature, and 3 seconds later, it will
recover and display the real temperature.
9. Adjust the CO
2
mechanism, and you can adjust the pressure regulator knob to control the beer flow rate and beer bubble.
Note: Clean the glass before pouring beer out; if the beer or beer cup/glass is in high temperature or
the beer is not cool enough, there are many bubbles when pouring beer out.
10. When taping the beer, lean your beer glass against the pouring spout and slowly straighten it up with
the beer rising, then open the tap mechanism completely to avoid much bubble; It is advisable to pour
half-glass, make a short pause before continuing the rest.
NOTES: Never immerse the pouring spout into the beer glass to avoid much bubble; Remember to
lock the tap after finishing pouring.
11. It is normal to have more bubbles when pouring the first 3 cup of beer.
12. There will be a sharp and high-speed jet when pouring the last cup of beer from keg.
Heineken Keg
Heineken kegs are pre-charged with CO
cartridge. And the knob on the top cover does not work.
29
pressure regulator knob to "+" position, to pour the beer out by pulling down the tap
, and do not require the use of regulator, no need to install the CO
2
℃
2