Autotrol Logix 740 Operation Manual page 7

Resetting The Control
SU MO TU WE TH FR SA DAYS
Time & Day
Regen Time & Day
Salt
Capacity
H
Hardness
Resetting the Logix Controller
SU MO TU WE TH FR SA DAYS
Time & Day
Regen Time & Day
Salt
Capacity
Hardness
Unprogrammed control after reset
Further programming or set-up instructions can be found in this manual
LOGIX™ SERIES INSTALLER QUICK-START SHEET
To reset the control:
1. Press and hold SET and DOWN simultaneously for 5 seconds.
2. H0 and the system's set resin volume (or "F" mode) will be displayed.
3. If a history value other than "H0" is displayed, use the up arrow to scroll
through the settings until "H0" is displayed.
4. To reset the control, press and hold SET for 5 seconds.
5. The control will be reset to an unprogrammed state.
6. Go to "Initial Set-up" section of this sheet to reprogram control.
WARNING: Resetting the control will delete all information stored in its
memory. This will require you to reprogram the control completely from
the initial power up mode.
7
Rev A