Figure 4
700 Series Controller Identification
Location Selection
14
Rev A
LCD Display
Front
Down Button
No Salt Detector
Connection
Back
Location of a water treatment system is important. The following
conditions are required:
•
Level platform or floor
•
Room to access equipment for maintenance and adding regenerant
(salt) to tank.
•
Ambient temperatures over 34°F (1°C) and below 120°F (49°C).
•
Water pressure below 120 psi (8.27 bar) and above 20 psi
(1.4 bar).
•
In Canada the water pressure must be below 100 psi (6.89 bar).
•
Constant electrical supply to operate the controller.
•
Total minimum pipe run to water heater of ten feet (three meters) to
prevent backup of hot water into system.
•
Local drain for discharge as close as possible.
•
Water line connections with shutoff or bypass valves.
•
Must meet any local and state codes for site of installation.
•
Valve is designed for minor plumbing misalignments. Do not support
weight of system on the plumbing.
•
Be sure all soldered pipes are fully cooled before attaching plastic
valve to the plumbing.
SU MO TU WE TH FR SA DAYS
Time & Day
Regen Time & Day
PM
Salt
MIN
LBS
x2
KG
Capacity
C
P
x100
H
Hardness
Up Button
Set Button
Main Motor &
Optical Sensor
Connection
740/760 Turbine Input or Dry Contact Signal Input
EQUIPMENT INSTALLATION
Manual Regen Button
AC Adapter
(low voltage)
Input