Wiring Harnesses
Figure 18 - Wire Harness
Routing
Wire Clips
Slots for Motor
and Turbine Harness
Latch
50
Rev A
The wiring harnesses are designed to fit one way. The connectors are
unique to the port they plug into. The wires are held in place by clips and
the connectors latch in place.
Do not run wires through holes in topplate.
To remove a wiring harnesses:
1. Disconnect power to the unit.
2. Remove cover.
3. Remove controller.
4. Remove connections by squeezing the latch on the connector and
pulling out.
5. Pull the harness out of the clips on the top plate.
Turbine
VALVE SERVICE