Program Alarm; System Alarm; Figure 4-15 Program Run Alarm - Code 17; Figure 4-16 System Error Alarm - Code 08 - Honeywell DC1000 Series Product Manual

4.3.4

Program Alarm

4.3.4.1 Segment End Alarm (Alarm Code 07)
Once the selected segment is completed, the alarm becomes activated
- ALD1 – ALD3
- AL1 – AL3
- ALT1 – ALT3
(0= Flickering, 99.59 = Continuous, Others = Time Delay*)
* If ALD1-ALD3 is "07" (in other words, the alarm is set as "segment end alarm"), the ALT means how long
the alarm is enabled (activated immediately and last during specified time).
* In case ALD1 - ALD3 is not "07" (in other words, the alarm is not set as "segment end alarm"), the ALT
means "Time Delay".
4.3.4.2 Program RUN Alarm (Alarm Code 17)
While a program runs, the alarm becomes actuated
4.3.5

System Alarm

4.3.5.1 System Error Alarm (Alarm Code 08)
4.3.5.2 System Error Alarm (Alarm Code 18)
4.3.5.3 Timer Alarm (Alarm Code 19)
Once the PV reaches the SP, the alarm becomes actuated after a certain time delay.
(Range: 00 hour 00 min – 99 hour 59 min)
8/05
Set the Alarm Code 07
Enter Segment No.for alarms
Define the alarm timing
Figure 4-15 Program RUN Alarm – Code 17
Figure 4-16 System Error Alarm – Code 08
Figure 4-17 System Error Alarm – Code 18
DC1010/1020/1030/1040 Product Manual
Configuration
33