Mitsubishi Electric GUG-01SL-E Technical Manual page 20

4
Outlines and Dimensions /
CHAPTER
GUG-02SL-E
170
An inspection opening is required for
installation and regular maintenance
(check) of the drain pump. When SA
temp. control is selected, another
inspection opening may be required in
front of the unit for SA thermistor
replacement only when an error
occurred on the SA thermistor.
GUG-03SL-E
250
An inspection opening is required for
installation and regular maintenance
(check) of the drain pump. When SA
temp. control is selected, another
inspection opening may be required in
front of the unit for SA thermistor
replacement only when an error
occurred on the SA thermistor.
17
Air inlet from
Lossnay
Control box
Inspection
450 x 450 or
Power supply
cable opening
Drain pipe (O.D φ32)
Maintenance cover for drain pump, inlet air
thermistor and water sensor
Heat exchanger
47
Air inlet from
Lossnay
Control box
Inspection
opening
450 x 450
or more
115
Power supply
cable opening
Drain pipe (O.D φ32)
Maintenance cover for drain pump, inlet air
thermistor and water sensor
1. Outlines and dimensions
Heat exchanger
Ceiling suspension fixture
(4-13 X 20 oval)
551
84
30
SA
(supply air)
opening
Drain pump
more
492
Ceiling suspension
115 186
fixture
47
52
Maintenance cover for SA thermistor
Gas pipe φ15.88
Liquid pipe φ9.52
Ceiling suspension fixture
(4-13 X 20 oval)
459
49 30
SA
(supply air)
518
Drain pump
461
340
55 Ceiling suspension
78
fixture
Maintenance cover for SA thermistor
Gas pipe φ15.88
Liquid pipe φ9.52
394
59 250
Unit (mm)
404
14 250
Unit (mm)