Mitsubishi Electric GUG-01SL-E Technical Manual page 35

(3)Initial settings from the menu
Press "MENU" button from the Main display and select "Initial setting" .
The following selections will be listed.
Main/Sub
•
Clock
•
Main display
•
Contrast
•
Display details
•
-Clock
-Temperature
-Room temp.
-Auto mode (Auto cooling/heating operation)
Auto mode (Auto cooling/heating operation)
•
Administrator password
•
Language selection
•
Make the initial setting for each if necessary.
Main/Sub setting
•
Please do not change from the factory setting.
Using two remote controllers connecting to one Dx-coil unit is prohibited.
Clock setting
•
Clock setting is necessary for time display, weekly timer, timer setting and error history.
Make sure to perform clock setting when the unit is used for the first time or has not used for a long time.
Main display setting
•
Use the F3 or F4 button to select the display mode "Full" or "Basic" . (The factory setting is "Full" .)
Remote controller display details setting
•
Make the settings for the remote-controller-related items as necessary.
Press the SELECT button to save the changes.
[1] Clock display
[2] Temperature unit setting
[3] Room temperature display
Please set to "No" for the SA temp. control.
[4] Auto mode (Auto cooling/heating operation) display setting
(RA temp. control only)
(The factory setting is "Yes" .)
Yes: "AUTO COOL" or "AUTO HEAT" is displayed during Auto mode
•
(Auto cooling/heating operation).
No : Only "AUTO" is displayed during Auto mode
•
(Auto cooling/heating operation).
Auto mode (Auto cooling/heating operation) setting (RA temp. control only)
•
· Yes: The Auto mode (Auto cooling/heating operation) can be selected in the operation mode setting.
· No : The Auto mode (Auto cooling/heating operation) cannot be selected in the operation mode setting.
(The factory setting is "Yes" .)
Administrator password setting
•
The initial administrator password is "0000" . Change the default password as necessary to prevent unauthorized access.
•
Have the password available for those who need it.
If you forget your administrator password, you can initialize the password to the default password "0000" by pressing and
•
holding the F1 and F2 buttons simultaneously for three seconds on the administrator password setting screen.
The administrator password is required to make the settings for the following items.
•
Timer setting
•
Weekly timer setting
•
Restriction setting
•
7
Remote Controller PZ-01RC /
CHAPTER
5. Initial setting
Display details
Clock No 24h
Temperature °C / °F / 1°C
Room temp. Yes / No
Auto mode Yes / No
Select:
Cursor Cursor
32