Power On/Power Off - Bosch VIP X1600 Installation And Operating Manual

VIP X1600 | Installation and Operating Manual

Power on/Power off

Power supply
The VIP X1600 does not have a power switch. Power is provided once one or
two power supply units have been installed.
Note
Information as to the selection of an appropriate power supply unit can be
obtained from your supplier or directly from Bosch Security Systems.
Caution
Only use power supply units approved by Bosch Security Systems.
Where necessary, use suitable equipment to ensure that the power supply
is free from interference such as voltage surges, spikes or voltage drops.
The unit is ready for operation after the VIP X1600 has been connected to the
power supply and the mounted VIP X1600 modules have been initialized.
The operational state of each module is indicated by an LED on the front side of
the VIP X1600.
If the network connection has been correctly set up, the green LED of the RJ45
socket ETH 1 is illuminated. A flashing orange LED indicates that data packets
are being transmitted across the network. In the case of a redundant network
connection, or a direct connection to an iSCSI server, these signals can also be
seen on the LEDs in the RJ45 socket ETH 2.
Note
For more information about the LEDs see page 117.
Bosch Security Systems | 2006-03 | V2.0
EN | 25
Installation