Power On/Power Off; Setup Using The Configuration Manager; Power Supply - Bosch VIP X1600 Installation And Operating Manual

VIP X1600
4.5

Power On/Power Off

4.5.1

Power Supply

The VIP X1600 does not have a power switch. Power is provided once one or two separate
power supply units have been installed. Connect the VIP X1600 to a power supply unit and
plug this into the mains. The unit is now ready for use. The VIP X1600 does not come supplied
with a power supply unit.
CAUTION!
Use only power supply units approved by Bosch Security Systems.
!
Where necessary, use suitable equipment to ensure that the power supply is free from
interference such as voltage surges, spikes or voltage drops.
Do not connect the VIP X1600 to the power supply until all other connections have been
made.
The unit is ready for operation after the VIP X1600 has been connected to the power supply
and the mounted VIP X1600 modules have been initialized.
The operational state of each module is indicated by an LED on the front panel of the
VIP X1600.
If the network connection has been set up correctly, the green LED of the ETH 1 RJ45 socket
will light up. The flashing orange LED signals that data packets are being transmitted over the
network. In the case of a redundant network connection, or a direct connection to an iSCSI
system, these signals can also be seen on the LEDs in the ETH 2 RJ45 socket.
4.6

Setup Using the Configuration Manager

The Configuration Manager program can be found on the product CD contained in the
VIP X1600 base's scope of delivery. This program allows you to implement and set up new
video servers in the network quickly and conveniently.
NOTICE!
i
Using the Configuration Manager to set all parameters in the VIP X1600 is an alternative to
configuration by means of a Web browser, as described in chapter 5 of this manual.
4.6.1 Installing the Program
1.
2.
3.
Bosch Security Systems
Insert the CD into the computer's CD-ROM drive.
If the CD does not start automatically, open the Configuration Manager directory using
Windows Explorer and double-click Setup.exe.
Follow the on-screen instructions.
Installation and Operating Manual
Installation | en 23
V3.5 | 2007.12