Pro-Cut PFM 9.2 DRO Technical Manual page 69

15. Once you have determined that there is enough material remaining to make a successful cut, advance the cutting
head to the inside of the rotor where you will begin the machining process. Set your depth of cut by turning the
cutting head knobs clockwise to the desired depth. Each line on the knob represents .001" of depth. We suggest a
minimum cut depth of .004", or 4 lines. Then tighten each cutting arm lock knobs, turn off the lathe motor, install
the chip deflector, position the shut off cam, depress the clutch knob and turn lathe motor back on to begin the cut.
WWW.PROCUTUSA.COM PG / Ø69