Pro-Cut PFM 9.2 DRO Technical Manual page 39

DRO DIAGNOSTICS CONTINUED
Press the START button again and the word "5 Adj." screen will be displayed. Press the START button once more and the
last five adjustment cycle times will be displayed in seconds. Press the START button once more and you will reach the
units display toggle. Pressing 'Start' will toggle between inch and metric (mm for thickness and microns for runout) display
modes. Press the START button one more time to enter Thickness Calibration mode.
This value represents the average compensation
time recorded in seconds over the life of the lathe.
Display of average compensation time of the last 5
successful compensation cycles.
WWW.PROCUTUSA.COM PG / Ø39