Pro-Cut PFM 9.2 DRO Technical Manual page 49

Table of Contents

Advertisement

THE GAGE PICK UP MODULE 50-1148
Remove the cover on the bottom of the bevel gearbox assembly. Replace it with the 50-1148 assembly,
taking care to aim the eight pin connector towards the lathe body. With the lathe unplugged from AC
power, seat the 6 pin connector from the slide sensor, and the 8 pin connector from the lathe's harness.
These are waterproof connectors and they seat firmly. Please make sure the small catch latches over the
post on the top of each connector to ensure a complete connection. Re-power the lathe.
*NOTE:
The Gauge Pickup module also performs cutting detection, but this feature is not used unless you
upgrade to a full GYR package.
ELECTRONIC READOUT:
When the lathe is plugged in you will see three letter/number combinations if you have connected every-
thing properly:
Lathe Adjustment Module & Version Number
Display Control Module & Version Number
Gauge Pickup Module & Version Number
If the Gauge Pickup Module is not connected you will see E.GPM instead of GP###. Always unplug the
lathe when connecting or disconnecting lathe electronics. It is unlikely that doing so while the lathe is
powered will cause any harm, but the electronics work best when they are all powered on and off simul-
taneously.
ASSEMBLY
(You will see digits, not the # symbol)
WWW.PROCUTUSA.COM
PG /
Ø49

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Pro-Cut PFM 9.2 DRO

Table of Contents