Pro-Cut PFM 9.2 DRO Technical Manual page 37

DRO EFFICIENCY TRACKING
The remaining screens are accessed through the START button and are scrolled through by continued pressing of the
START button. The machine first must be in the Ready mode and the motor must be off. Press and hold the START
button until all of the lights come on, then release and "H0.800" will be displayed. This is the thickness calibration
screen for the G2X measuring cutting head. Further information on calibrating the measuring cutting head can be
found on page 50. Then, press the START button again and release and the hour screen will be displayed. Press
again and release and the actual number of hours the motor has run will be displayed in hours and tenths of an hour.
| The first diagnostic screen
This value represents hours and tenths of an hour
that the motor has to run.
WWW.PROCUTUSA.COM PG / Ø37