SERVICE CORRIDOR CONCEPT
Turn the lathe motor on and adjust for lateral run-out by touching the green "Begin LRO Adjust" button on
10.
the touch screen.
NOTE:
LRO Adjustment in Process
Once the lateral run-out is corrected "LRO Adjust Complete" will be displayed in the yellow command bar,
11.
and the actual LRO will be displayed as well.
12.
Touch the "Next" command in the lower left hand of the touch screen.
13.
Center the cutting head over the brake rotor as per your lathe's owner's manual.
PG /
800.543.6618
Ø62
CONTINUED