A P P E N D I X A : M O D B U S I N T E R F A C E R E G I S T E R S
MODBUS FUNCTION USE
01 Discrete Coil Status
02 Discrete Input Status
03 Holding Register
OWDMANUAL 1114
Reads output coil status,
digital outputs
Reads state of individual
digital inputs
Reads and writes to
the DAC channels (0-3).
Takes a converted float
value (from 2 unsigned
int values) and updates
the DAC output values
(in Volts 0-10VDC).
REGISTERS
0x00001–0x00016: Digital outputs 0–15
0x10001–0x10024: Digital inputs 0–23
0x40001–0x40002: Float value for DAC 0
0x40003–0x40004: Float value for DAC 1
0x40005–0x40006: Float value for DAC 2
0x40007–0x40008: Float value for DAC 0
40100–40999: 16–bit values
41000–41999: 32–bit values
42000–44999: Float values
45000–47299: Modbus registers
40100: Alarm setpoint
40101: Alarm setpoint prior to change
40102: On or off alarm report
40103: On or off alarm report
40104: On or off alarm report
40105: True when value over alarm value for dead-band
time. Reset when value below alarm value for
dead-band time.
40106: Signal to reset transaction
40107: Water content integer
40108: AD0 raw value
40109: AD1 raw value
40110: Low-end output at 4ma prior to change
40111: Low-end output at 4ma
40112: High-end output at 20ma
40113: High-end output at 20ma prior to change
40114: Number of user block saves (Limit to 50,000)
41000: Sample period in seconds
41001: Sample period in seconds prior to change
41002: Alarm dead–band inter-value timer
41003: Alarm dead–band start time
41004: Alarm dead–band current time
41005: Alarm inter-value timer
41006: Alarm start time
41007: Alarm current time
41008: Array of time of alarms
41009: Array of time of alarms
41010: Array of time of alarms
41011: Value at time of alarm
41012: Value at time of alarm
41013: Value at time of alarm. Reset when value below
alarm value for dead-band time.
41014: Amount of measured material
41015: Material less water
41016: Average water
41017: Transaction intervalue timer
41018: Transaction start time
41019: Sample period in second
35
KAM CONTROLS, INC.
Need help?
Do you have a question about the Simple Precision OWD and is the answer not in the manual?