Kalor Ada 28B User Manual page 45

To do this, the horizontal pin can be pulled through a hole
in the wall of the Thermostove body.
Now the upper section to the heat exchanger is free from any
encumbrance so as to allow a perfect cleaning. Once a year
is also recommended to clean the upper compartment of the
exchanger. To make a proper cleaning is recommended to
suck the ash, remove all horizontal joints with a screwdriver,
then again suck the ash.
The transaction can be completed with a screwdriver by
removing the wall of the Thermostove and removing all
horizontal joints.
Following the cleaning of the upper compartment of the exchange section, store the upper closure cover.
This cover must be closed, as well as with normal screws, with webbing in ceramic fiber rope to ensure the watertight
closure of the Thermostove. This general cleaning should be carried out at the end of the season in order to facilitate
the general removal of all residues of combustion, without waiting too long, because with time and humidity these
residues can become compacted. Check the seal of the ceramic fiber gaskets on the door of the Thermostove. Then
clean the flue system especially near the fittings to "T" and any horizontal sections.
For your safety, the frequency of cleaning the smoke discharge system must be
determined on the basis of how the Thermostove is used.
93