Kalor Ada 28B User Manual page 44

Maintenance and cleaning for all models
Cleaning the steel flame-shell
Every 2-3 days it is important to remove the steel flame-
shell in order to clean it and remove the dirty that may fall
during the cleaning of the exchange pipes.
Shutting the Thermostove down
In the period when the Thermostove is out of use it must be
disconnected from the electricity mains. For greater safety,
especially if there are children around, we recommend
removing the power cable from the rear of the Thermostove.
Before placing the Thermostove in storage, you should remove all pellets from the hopper with a vacuum cleaner with a
long extension. If the fuel is left in the hopper, it may get damp, stick together, and be difficult to light at the beginning of
the next season. If pressing the main switch (located on the back of the Thermostove) does not make the control panel
display light up, it could mean that the service fuse needs replacing. On the rear of the Thermostove there is a fuse holding
compartment which is located underneath the supply socket. With a screwdriver open the cover of the fuse holding
compartment, and re place the fuse if necessary (3,15 AT delayed type). Plug the unit back in and press the main switch.
CLEANING BY THE TECHNICAL
Check every year
Compartment ventilation flue gas cleaning
Remove the fixing screws and remove the smoke fan for cleaning of the same. Perform the task with the greatest care not
to bend the fan blades.
Clean flue
Clean the flue system especially near the fittings to "T", curves and any horizontal sections. Is necessary to check and
remove any deposit of ash and soot before the same clogging the passage of smoke.
Cleaning the exchanger
Lift the upper door that covers the tube by unscrewing the
screws. Pull out the 16 soft brush and wipe with a clean 16
exchanger tubes.
Perform cleaning after removing the springs inserted in
each pipe. The operation is simple by removing the springs
from the horizontal pin to which they are attached.
92