12Turning On The Main Power; 13Stirring The Toner; 14Setting The Cassette - Canon iR6570 Series Installation Procedure

[2]
[1]
F-1-43
1.2.12 Turning on the Main
Power
iR5570 / iR6570
Before turning on the main power, make sure to
eliminate the packing materials in the cassette.
1) Pull out the duplexing unit and make sure that there
is no foreign matter or damage.
2) Make sure that the main power switch turns off, and
connect the power plug to the power outlet.
3) Turn on the main power switch.
- The indication of loading programs appears.
- The message [Wait...]Is displayed.
How to turn off the main power:
When turning off the main power, follow the
procedure below in order to protect the hard disk of
the machine.
1. Press the power switch on the control panel for 3
sec or more.
2. Operate the touch panel following the instruction
display for the shut down sequence so that the main
power switch can be ready for turning off.
3. Turn off the main power switch.
1.2.13 Stirring the Toner
iR5570 / iR6570
After waiting until the machine is ready for operation,
supply the toner from the hopper to the developing
unit by operating in service mode.
1) Start service mode. (Press the '*' key, '2' and '8' at
the same time, and the * key once again.)
2) Make the following selections:
COPIER>FUNCTION>INSTALL>TONER-S.
3) Make sure that the message, 'CHECK THE
DEVELOPER' appears.
0008-8066
4) Check to see if the developing assembly is properly
locked in place, and press the OK key.
- The supplying operation will last for about 8min to
10min,
automatically.
- Perform the cassette setting before the toner
supplying operation is completed. (Refer to the
cassette setting.)
Do not turn the power off during the operation.
1.2.14 Setting the Cassette
iR5570 / iR6570
1) Press the cassette releasing button, and slide out the
cassette to the front.
2) Set the side guide plate [1] of each cassette to the
hole (A4/A3) of the stamp M [2].
after which the operation
Chapter 1
0008-8071
stops
0008-8103
19