19Adjusting Leading Edge Registration; 20Getting The Machine Ready For Installation - Canon iR6570 Series Installation Procedure

Chapter 1
1) Move the side plates [1] to the center. Loosen the 2
mounting screws [2] of the manual feed tray, and
adjust the position of the manual feed tray.
F-1-57
<Duplexing Feeder Unit>
1) Select the following service mode COPIER >
ADJUST > FEED-ADJ > ADJ-REFE, and make an
adjustment so that margin on the 2nd side image
will be within specs.
Decrease the value of
ADJ-REFE
(Margin is decreased by
1mm with decrease of 10)
F-1-58
1.2.19 Adjusting Leading
Edge Registration
iR5570 / iR6570
1) Select the following service mode COPIER >
ADJUST > FEED-ADJ > REGIST, and make an
adjustment so that margin will be within specs.
F-1-59
24
[1]
Increase the value of
ADJ-REFE
(Margin is increased by
1mm with increase of 10)
2.5+/-2.0mm
0 0
2 2
4 4
6 6
8 8
10 10
0008-8559
Decrease the value of REGIST
(Margin is increased by 1mm with decrease of 10)
Paper leading edge
Increase the value of REGIST
(Margin is decreased by 1mm with increase of 10)
1.2.20 Getting the Machine
Ready for Installation
iR5570 / iR6570
<Storing the drum rotation tool and grip>
1) Remove the 2 screws, and detach the right rear
bottom cover; store the parts below.
1. Drum rotation tool [1]: Store it inside the waste
toner case cap in the hole of the drawer grip at the
top of the waste toner case [2].
2. Grip (included in the package): Store it in the grip
storage area [3].
[3]
F-1-60
The drum rotation tool and the cap cannot be stored if
the drawer grip is fully drawn out. Therefore, draw out
the grip in moderation as shown the fig. below.
0008-8111
[1]
[2]