Removing The Clock Sensor; Optional Tray Driver Pcb; Removing The Stack Tray Assmbly Harness; Removing The Tray Guide Top Cover - Canon Additional Finisher Tray-C1 Service Manual

Chapter 3

3.4.4.4 Removing the Clock Sensor

1) Remove the harness from the four wire saddles [1] and three mini-clamps
[2], and then remove the four binding screws (M3 x 4) [3].
2) Disconnect the connector [4], and then remove the tray clock sensor [5].
[5]
[3]

3.4.5 Optional tray driver PCB

3.4.5.1 Removing the Stack Tray Assmbly Harness

1) Remove the screw [1], and then remove the sensor mounting plate [2].
2) Remove the harness from the two wire saddles [3], and then remove the
reusable band [4].
[4]
3-6
[1]
F-3-30
[4]
[2] [3]
[1]
F-3-31
[3] [2] [1]
F-3-32

3.4.5.2 Removing the Tray Guide Top Cover

1) Remove the two RS tightening screws (M3 x 8) [1], and then detach the
rear cover [2] of the tray.
[1]
0010-6804
F-3-33

3.4.5.3 Removing the Stack Tray Assembly

1) Holding the stack tray [1], remove it in the direction of the arrow.

3.4.5.4 Removing the Bottom Cover of the Optional Tray

1) Remove the two P tightening screws (M4 x 12) [1], and then remove the
bottom cover [2] of the optional tray.
0010-6809

3.4.5.5 Removing the Optional Tray Drive PCB

1) Disconnect the four connectors [1], remove the three binding screws (M3
x 4) [2], and then remove the optional tray driver PCB [3].
[2]
[1]
F-3-34
[1]
[2]
F-3-35
0010-6810
0010-6811
0010-6812
0010-6813