Table of Contents
Advertisement
4.1 Maintenance and Inspection
4.1.1 Periodically Replaced Parts
4.1.1.1 Periodically Replaced Parts
The machine does not have parts that must be replaced on a periodical basis.
4.1.2 Durables
4.1.2.1 Durables
This machine does not have items that may be classified as durables.
4.1.3 Periodical Servicing
4.1.3.1 Periodical Servicing
The machine does not have items that must be serviced on a periodical basis.
4.2 Variable Resistors (VR), Light-Emitting Diodes (LED), and Check Pins by PCB
4.2.1 Functions of the DIP Switch
The DIP switch (SW1) on the finisher controller PCB possesses the following functions:
-Press it to switch over operation.
-Shift all bits of SW1 at the end of a check.
1.Checking the Operation of the Stack Unit
ON
1
2
3
4
F-4-1
Operations
<With the Option Tray at the Position of Paper Surface Detection>
1.The option tray moves down 20 mm (until it turns off the paper surface sensor).
2.The option tray moves up and stops when it turns off the paper surface detection sensor.
<With the Option Tray Not at the Position of Paper Surface Detection>
1.The machine executes a series of operations used o move the option tray to the position of paper surface detection.
<Moving the Stack Tray for Packing>
-Use it to move the tray so that it will be located suitably for packing.
Chapter 4
0010-1724
0010-1725
0010-1726
0010-1728
4-1
Advertisement
Table of Contents
