Canon Additional Finisher Tray-C1 Service Manual page 28

Chapter 3
[1] [2]
F-3-18
3.4.2.3 Removing the Stack Tray Assmbly
1) Holding the stack tray [1], remove it in the direction of the arrow.
3.4.2.4 Removing the Stack Tray Upper Limit Sensor
1) Disconnect the connector [1], and then remove the stack tray upper limit
sensor [2].
3.4.3 Static Charge Eliminator 1
3.4.3.1 Removing the Stack Tray Assembly Harness
1) Remove the screw [1], and then remove the sensor mounting plate [2].
2) Remove the harness from the two wire saddles [3], and then remove the
reusable band [4].
3-4
[1]
F-3-19
[1] [2]
F-3-20
3.4.3.2 Removing the Tray Guide Top Cover
1) Remove the two RS tightening screws (M3 x 8) [1], and then detach the
rear cover [2] of the tray.
0010-7689
[1]
F-3-22
3.4.3.3 Removing the Stack Tray Assmbly
0010-7690
1) Holding the stack tray [1], remove it in the direction of the arrow.
0010-6814
3.4.3.4 Removing the Bottom Cover of the Optional Tray
1) Remove the two P tightening screws (M4 x 12) [1], and then remove the
bottom cover [2] of the optional tray.
[4] [3] [2]
F-3-21
[2]
[1]
F-3-23
[1]
0010-6815
0010-6816
0010-6817