Table of Contents
Advertisement
4.
Configure ACL-based GTS on the
interface.
Configuring queue-based GTS
This feature is supported only on SAP modules operating in bridge mode.
To configure queue-based GTS:
Step
1.
Enter system view.
2.
Enter interface view
or port group view.
3.
Configure GTS for a
queue.
Configuring GTS for all traffic
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure GTS on the interface.
Configuring the rate limit
The rate limit of a physical interface specifies the maximum rate of outgoing packets.
To configure the rate limit:
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the rate limit
for the interface or port
group.
qos gts acl acl-number cir committed-information-rate
[ cbs committed-burst-size [ ebs excess-burst-size ]
[ queue-length queue-length ] ]
Command
system-view
•
Enter interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
qos gts queue queue-number cir
committed-information-rate [ cbs
committed-burst-size ] [ ebs
excess-burst-size [ queue-length
queue-length ] ]
Command
system-view
interface interface-type interface-number
qos gts any cir committed-information-rate [ cbs
committed-burst-size [ ebs excess-burst-size ] [ queue-length
queue-length ] ]
Command
system-view
interface interface-type
interface-number
qos lr inbound cir
committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ]
38
Remarks
N/A
Use one of the commands.
Settings in interface view take
effect on the current interface.
Settings in port group view take
effect on all ports in the port
group.
N/A
Remarks
N/A
Use one of the commands.
Settings in interface view take
effect on the current interface.
Settings in port group view take
effect on all ports in the port group.
N/A
Advertisement
Table of Contents
