Shuttle FX43G User Manual page 68

HDD Power Down
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disabled.
Ø The choice: Disabled or 1 Min~15 Min.
Suspend Mode
When this item is not disabled and after the setup time of system inactiv-
ity, all devices except the CPU will be shut off.
Ø The choice: Disabled, 1 Min, 2 Min, 4 Min, 6 Min, 8 Min, 10 Min,
20 Min, 30 Min, 40 Min, or 1 Hour.
Video Off Option
This item specifies on/off for the monitor when it enters the power-
saving mode.
Ø The choice: Always On or Suspend ->Off.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
Blank Screen
DPMS Support
Ø The choice: V/H SYNC+Blank, Blank Screen, or DPMS Support.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø The choice: 3, 4, 5, 7, 9, 10, 11, or NA.
Soft-Off by PWRBTN
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay
4 Sec, then you have to hold the power button down for 4 seconds to
cause a software power down.
Ø The choice: Delay 4 Sec or Instant-Off.
Run VGABIOS if S3 Resume
This item defines if the VGA BIOS runs when the system wakes up from
S3.
Ø The choice: Auto, Yes or No.
Power fail resume
The system power status after the resume of power fail.
Ø The choice: OFF or ON.
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
The item only writes blanks to the video buffer.
Initial display power management signaling.
- 63 -