Flight Controller; Video Transmitter - Team Blacksheep TBS OBLIVION Manual

● General​ - OSD specific settings
Show Position​ - No/Yes - Display the GPS coordinates on the bottom of the screen, update
○
rate 1Hz - useful while watching a DVR recording to recover a downed aircraft
○ Show Heading​ - No/Yes - Show heading arrow pointing towards "home" base
Show Sats​ - Hide on fix/Always - Number of GPS satellites available and locked
○
OSD Color​ - White/Black - Color of text and outline, i.e. white core and black outline/glow
○
○ Power Index​ - Off / mAh/Min / mWh/Km mWh/Mi / mAh/Km mAh/Mi - Running indicator
of power economy
Warn. Show Time​ - 0.5 to 60.0 Seconds - Duration of how long warnings stay on the
○
screen, default for racers target is 0.8s and 2.5s for every other target
○ Summary Style​ - TBS/PAO/Off - End of flight summary screen layout, TBS style with
judgement or without (PAO)
Audio Telemetry​ - Off/ImmersionRC - ​
○
bridge closed and ImmersionRC decoder is attached to the VRX
OSD Type:​ CORE PRO/OBLIVION - Changes the power up text to CORE PRO or OBLIVION
○
Factory Reset​ - Reset all CORE PRO settings to default
○
● Artificial Horizon​ - Uses the gyro and accelerometer to estimate level plane
Show Horizon​ - Off/Basic - Shows a line in the middle of the display to indicate level
○
position
● Callsign​ - Personal HAM licence number
Show Callsign​ - Minutely/Always/Off - Display the HAM callsign and mm:ss timer on the
○
lower-left corner
Enter Callsign​ - 0 to 10 characters - Enter your callsign, defaults to "TBS"
○
Flight Controller
PID​ - Detailed Proportional–Integral–Derivative controller values for Roll, Pitch and Yaw
●
● Rate - ​ S tick sensitivity multiplier values
Settings​ - Looptime and Idle Motors settings
●
● Calibration​ - RC/Radio Calibration wizard for setting up the receiver or this can also be done in
CleanFlight and the data read back to the CORE PRO. Run the accelerometer calibration on a
leveled surface
● Filters​ - Advanced setup of Gyro and PD Cut Frequency settings
Video Transmitter
● VTX Unlock​ - Brings you to Callsign settings to change the id from the default "TBS"
Band​ - A/B/Race/E/Airwave/User - Video transmitter frequency band
●
● Channel​ - 1 to 8 - Channel number (frequency) within the selected band, see UNIFY PRO manual
Power Level​ - 25/200/500/800mW - Transmitter output power level
●
● VTX LED Strip​ - Disable/Enable - Changes color depending on the frequency used, rainbow color
from lowest (red) to highest (violet)
W hen you do not use TBS UNIFY, the TELM solder
27