Transporting Or Shipping The Charger - Thermo Scientific Vanquish Charger Operating Manual

7 • Maintenance
7.5

Transporting or Shipping the Charger

Preparing the Charger for Transport
Page 62
If you want to transport the Charger to a new location or if you need to
ship the Charger, first prepare the Charger for transport and then move
or ship the Charger as required. Follow the instructions in this section.
Observe the following safety guidelines:
Installation by Service Engineer only
Service personnel certified by Thermo Fisher Scientific must perform the
installation (for brevity, referred to as Thermo Fisher Scientific service
engineer).
If it is required to re-attach the Charger to the Vanquish autosampler
after transport, contact Thermo Fisher Scientific Technical Support for
assistance.
Observe all warning messages and precautionary statements presented
in section 2.3 Safety Precautions
CAUTION—Heavy Load, Bulky Device
The Charger is too heavy or bulky for one person alone to handle safely.
To avoid personal injury or damage to the Charger, observe the following
guidelines:
•
Physical handling of the Charger, including lifting or moving, requires
a team effort of two persons.
•
To lift or move the Charger, grasp the Charger by the sides. Do not
move or lift the Charger by the front door. This will damage the door
or the Charger.
To prepare the Charger for transport, follow these steps:
1. Shut down the Charger as described in
particular, verify that the shelf and any samples were removed from
the Charger compartment before you continue.
2. Disconnect the power cord.
(see page 19).
section 6.6, page
Vanquish Charger Operating Manual
54. In