I User Functions - Zodiac Z400 iQ Instructions For Installation And Use Manual

2.4 I User functions

2.4.1 Locking/unlocking the keyboard
To lock or to unlock the keypad,
2.4.2 Adjusting the temperature setpoint
• Press or : the temperature setpoint is displayed and flashes,
• Press to increase the temperature by 0.5 °C*,
• Press to reduce the temperature by 0.5 °C**.
• Press to confirm the desired setpoint temperature.
• The settings screen is automatically exited after 3 seconds of inactivity on the keypad or by pressing and releasing
The heat pump stops automatically when the pool reaches the required temperature.
*Maximum setpoint temperature = 32 °C.
**Minimum setpoint temperature = 15 °C.
If the setpoint temperature has not been confirmed by pressing
returns to the home screen (which takes place automatically after 3 seconds of inactivity on the keypad or
by pressing and releasing
2.4.3 Activating/deactivating "silence" mode
«Silence» mode is used to reduce the noise level emitted by the heat pump.
The appliance will operate for a longer period of time with less power, however with a lower noise level.
There are 2 ways to activate the "Silence" mode:
1 method
st
• Press and release
2 method
nd
• Press and hold
• Press or to display:
• Press and release
• The home screen automatically reappears after 60 seconds of inactivity on the keypad or by pressing and releasing
To deactivate the "Silence" mode, redo the manipulation, the symbol
2.4.4 Activating/deactivating "cold" mode
Activation of «Cold» mode allows the machine's cycle to be automatically reversed to cool the pool water when it
exceeds the setpoint temperature by more than 2°C.
• Press and hold
• Press or to display :
• Press and release
• The home screen automatically reappears after 60 seconds of inactivity on the keypad or by pressing and releasing
To deactivate the "cold/cooling" mode, redo the manipulation, the symbol
«Cold» mode does not allow cooling to be activated manually.
For immediate activation, activate «Cold» mode then return to the main screen and lower the setpoint
temperature to at least 2 degrees below the measured water temperature.
14
press and hold
).
, the symbol will light up.
.
, the symbol will light up.
, the symbol will light up.
and simultaneously for 3 seconds:
, it will not be saved if the interface
will go out.
will go out.
or .
.
.
.