Pic Test Section 4; Pic Test Section 5 - HP MICRO 3000 Diagnostic Manual

Error Codes
PIC Test Section 3
This section tests the Btl-ill
~oniroiier
chip Status Register (PIC Register
n
Code Error
0301
Initialization error - bits 0 to 7 should be zero.
0302 Initialization error - bits 10, 13, and 14 slhluld he 7.cro
ami bits I I and 12 should be one.
0303 Hit 13 should be I, bit 14 should be zero when the IIP-IB
controller chip is addressed to talk, but not listen.
0304
Bits 13 and 14 should both be one when the liP-In controller
chip is addressed to talk and listen.
0305 Bit 14 should be one, bit 13 should be 7.cro when the 111'-18
controller chip is addresscd to listen, but not to talk.
0306
nits 13 and 14 should both be zero whcn the liP-In controller
chip is not addressed to talk or to listen.
PIC Test Section 4
This section tests the liP-III controller I.:hip Interrupt Register (PIC Register 2) and Interrupt Mask
Register (PIC Register 3).
Code Error
0401
Reg2, bit 0 should be set (an interrupt is pending).
0402 Reg
2,
bits
9
and
13
should be clear
(no handshake abort and inbound FIFO empty).
0403 Reg2, bit 12 should be set (outbound FIFO room available).
0404 Reg 2, bit 14 should be set (out bound FIFO idle).
0405
Reg2, bit 8 should be clear (no status change).
0406 Reg 2, bit 0 should be clear (no interrupt pending).
0407 Reg 2, bit 8 should be set (status change occurred).
0408 Reg2. bit 9 should be clear (no handshake abort).
0409
Reg 2, bits 12 and 14 should be clear. nit I 3 should be set
(outbound FIFO rOlll11 not available, l)utbllUlHI FIFO not idle,
and
illh,llll11i
FiFO
not empi
y.
._>
FIFO Oits iii
uprh'siCc
state).
040A Reg 2, bit 9 should be set (handshake abort).
0406
Reg2. bit 9 should be clear (no handshake abort).
DEC 86