Preparing The 89600; Scpi Preferences - Agilent Technologies X Series Startup Manual

X-Series Measurement Applications for Modular Instruments Startup Guide
M9391 PXI Receiver: 1.2.300.0
M9393 PXI Receiver: 1.0.72.1

Preparing the 89600

Before attempting to run the 89600 in-process with the M90XA, you must prepare the SCPI Connection Type
and the Hardware Configuration as described below.

SCPI Preferences

When the 89600 is running in-process with the M90XA and a SCPI connection is being used to communicate
with the 89600, conflicts can arise. To avoid potential conflicts:
The 89600 must
If Telnet or Socket connection types are used, the port numbers must
on the M90XA
The M90XA must be started before the 89600 VSA Software.
If the 89600 .NET API is being used then the 89600 connection type should be set to None.
To set the connection type, start the 89600 VSA Software normally, then select Utilities > SCPI Preferences.
Then, set the Connection Type. The setting will be persisted when you close the 89600 VSA Software.
not
be configured to use a HiSLIP connection type.
not
conflict with port numbers
30