Preparing For Setup - Agilent Technologies NFA Series Setup Manual

Preparing for Setup

Check the Power Requirements
CAUTION This instrument is designed for use in Installation Category II and
Pollution Degree 2 per IEC 61010 and 60664 respectively.
WARNING If this instrument is not used as specified, the protection
provided by the equipment could be impaired. This instrument
must be used in a normal condition (in which all means of
protection are intact) only.
This instrument has autoranging line voltage input. Be sure the supply
CAUTION
voltage is within the specified range.
The Noise Figure Analyzer is a portable instrument and requires no
physical installation other than connection to a power source. There is no
need to select a line voltage. The AC power requirements are as follows:
• Voltage: 90-132 Vrms (47 to 440 Hz) or 195 - 250 Vrms (47 to 66 Hz)
• Power consumption when on: less than 300 W
• Power consumption when in standby mode: less than 5 W
Preparing for Setup
2