Verification Steps; Status Signaling Group - Avaya S8300 Installing And Configuring

5. Verification Steps

The following are the verification steps:
• Use the commands status signaling-group 20 to check the signaling group is in service.
status signaling-group 20
Group ID: 20
Group Type: h.323
Signaling Type: facility associated signaling
Group State: in-service
• Make a call from extension 61000 (Cisco CallManager phone) to extension 4555 (Avaya
IP telephone). Use the command show gatekeeper call from the Cisco 2811 Gatekeeper
and verify that this is a gatekeeper controlled call. Note that bandwidth (BW) is shown 16
(Kbps), which is the VoIP call with G.729 codec. Also, the call is between two endpoints
extension 61000 and 4555 as shown below.
GateKeeper#show gatekeeper call
Total number of active calls = 1.
LocalCallID
542-195
Endpt(s): Alias
src EP: Trunk-to-Gatekeeper_1
CallSignalAddr
60.1.1.5
Endpt(s): Alias
dst EP:
CallSignalAddr
22.1.1.22
SZ; Reviewed:
SPOC 8/10/2007

STATUS SIGNALING GROUP

GATEKEEPER CALL INFO
====================
6
E.164Addr
61000
Port R ASSignalAddr
54155 60.1.1.5
E.164Addr
4555
Port RASSignalAddr
1720 22.1.1.22
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
Active NCA-TSC Count: 0
Active CA-TSC Count: 0
Age(secs) BW
16 (Kbps)
Port
59507
Port
1719
28 of 30
ACM-Cisco-CM-GK.doc