D - Safety Information; D.1- Remaining Risks According To Iso En 12100-2; Safety Decals; Intended Use - BLUM MINIPRESS P Manual

D.1- Remaining risks according to ISO EN 12100-2

• This machine complies with current safety standards. However, risks remain for
• the operator and second persons due to the stroke movement of the drilling unit and especially in case safety devices are removed
or control elements should fail.
• Other remaining risks are indicated by the safety decals and in the following safety rules. It is therefore absolutely necessary to fol-
low all safety instructions carefully.
D.2 - Safety decals
Completely read the operating instructions and the safety information before operating the assembly machine
Wear proper eye and face protection when operating this machine
Only one person at a time must operate the machine.
The work area is located in front of the machine.
Electrical connections and maintenance should only be performed by a qualified electrician.
Disconnect electrical and pneumatic connections before making any repairs (plug / rapid hose coupling).
Keep hands away from the drill or swing arm during the drilling or insertion process.
Do not remove safety devices - danger of injury.
Keep hands away from the danger zone of the clamps and knurled screws. - danger of being crushed
Class 2 laser - Never look directly into the laser beam. The laser can cause eye damage.
D.3 - Intended use
• The designated purpose of the assembly machine is the drilling and insertion of furniture fittings into work pieces made of wood,
particle board or plastic coated wood. The assembly machine should only be used in manufacturing. The manufacturer does not
assume liability for uses not described in the instruction manual.
• The machine is not explosion-proof. It should not be set up near a paint finishing system
• The intended purpose of laser module MZR.5300 is measurement and position determination on the work piece in conjunction
with MINIPRESS P. Only wood or particle board should be used as the work piece since they are non-reflective. Coated and/or
reflective work pieces may not be used. Laser module MZR.5300 may only be used in combination with MINIPRESS P in commer-
cial and industrial applications. The manufacturer does not assume liability for uses not described in this instruction leaflet or the
MINIPRESS P instruction leaflet.
D.4 - Safety information
• Before retooling, cleaning, maintenance or performing any work on drill bits, turn the main switch
assembly machine from the pneumatic connection.

D - Safety information

6
(3.1) to pos. 0 and disconnect the
BA-101/3EN M53.XXXX