15) Clipping Furniture Hinge On To The Insertion Ram; 16) Drilling; 17) Checking The Tilt Adjustment Of The Swing Arm; 18) Inserting The Furniture Hinge - BLUM MINIPRESS P Manual

3.8
L
1.7
3.21
3.8
3.8
L
1.7
3 - Assembly

3.1.15) Clipping furniture hinge on to the insertion ram

3.1.16) Drilling

2.1
ATTENTION:
2.2
All items except for the work piece should be removed from the work
2.3
area of the assembly machine. Keep your hands out of work area (A).
• Main switch
• Hold down clamp
• Swing arm (3.8)
• Hold down door outside of danger area (A) and press against the swivel stop
• Press feed switch
• Release feed switch (2.2).

3.1.17) Checking the tilt adjustment of the swing arm

• Swivel down swing arm
• Check whether or not the furniture hinge is aligned with the drilling.
• If it is misaligned, this can be caused by two things:
a) Swivel arm
- Use the screw to correct this setting
b) Insertion ram is off-centre:
- Correct this setting using the adjustment screws
IMPORTANT:
!
If the feed switch
and insertion assembly moves downwards at creep speed.

3.1.18) Inserting the furniture hinge

2.1
ATTENTION:
2.2
Keep your hands and other objects away from assembly machine work
2.3
area (A)
• Press the feed switch
• Release feed switch (2.2).
• Swivel up swing arm
• Loosen the hold down clamps by touching the
hold down clamp switch
• Remove door from the work top or push to the next stop.
(2.1) at Pos. 1
(2.3) at Pos.
must be swivelled up.
(2.2) until drilling depth is reached.
(3.8) to the stop.
(3.8) is not set vertical.
(3.21)
(2.2) is only lightly pressed a few millimetres, the drill
(2.2) until the furniture hinge is inserted completely.
(3.8)
(2.3)
17
(3.8)
(3.22) on the insertion ram.
BA-101/3EN M53.XXXX
(1.7)