4) Attaching Swivel Stops; 5) Attaching Work Table; Connecting To Compressed Air System; 1) Connecting Air Supply - BLUM MINIPRESS P Manual

Hide thumbs Also See for MINIPRESS P:
Table of Contents

Advertisement

mwttttt mmmmtm tmttt ttt tmttttttmt mttt mwttttt mmm
mwttttt
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttttt mmm
mwtt tttmmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttttt mmm
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttt ttmmm
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwtttttmm mmtm tmttt ttt tmttttttmt mtt
mwttttt mmhb nhnhn hhnh nmmtm tmttt ttt tmtttlkl kll lkkltttmt mttt
mwttttt
mwt
XXX V / XX HZ
mwt
1 - Assembly machine setup

1.1.4) Attaching swivel stops

• Loosen clamping knob until the counter plate protrudes 10 mm
• Attach swivel stop to ruler at an angle and stand upright
• Tighten clamping knob
Note:
!
This procedure can also be used to set a stop between two available
stops.

1.1.5) Attaching work table

a) Accessory work top MZA.5300 table
• Set work table on runner plate
• Attach work table to runner plate
b) User-supplied work table (see Chapter 8 - Appendix)
ATTENTION:
The assembly machine should not be operated without the work top.
The work top must be securely fastened to the assembly machine using
the included fixing screws.

1.2 - Connecting to compressed air system

1.2.1) Connecting air supply

ATTENTION:
During the following procedure, the drill unit
makes an upward motion
• Connect the air supply to the air filter unit
• Open stop valve
Important:
!
A rapid hose coupling must be inserted a max. 3 m from the machine in
the air pressure supply line.

1.2.2) Setting operating pressure

• The operating pressure is 6 bar
(Pmin = 5 bar)
(Pmin = 7 bar)
• Air consumption per work cycle is 1.5 litres

1.3 - Electrical connection

1.3.1) Electrical connection
• The assembly machine is equipped with a mains plug. If the mains plug cannot be
used, the following steps should be carried out:
ATTENTION:
The electrical connection must be performed by a qualified electrician!
11
(3.23)
(1.8)
of the assembly machine
BA-101/3EN M53.XXXX

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents