9) Placing Cabinet Side On The Work Top And Pushing Up Against The Stop Or Marking Line; 10) Setting Hold Down Clamps To The Material Thickness; 11) Drilling; 12) Loosing Hold Down Clamps - BLUM MINIPRESS P Manual

X
3.8
1.7
L
4 - Assembly
b) If the bottom edge of the door should be shorter or longer than the bottom edge of
the carcase, the stops
dition, the base ruler
Positioning stops and rulers:
• Shift stops by measurement (x)
• Loosen screws
• Move ruler 16 mm in the direction of the outside drill bit
• Secure screws
IMPORTANT:
!
This step will align the 0 point offset for the cruciform mounting plate.
(see figure 4.1.8)
4.1.9) Placing cabinet side on the work top and pushing up against the stop
2.1
or marking line
2.2
(See point 3.1.12)
2.3
4.1.10) Setting hold down clamps
(See point 3.1.13)

4.1.11) Drilling

(See point 3.1.16)
4.1.12) Releasing hold down clamps
• Briefly press hold down clamp switch
• Push cabinet side to the next stop.
(1.7) must be set according to the measured difference. In ad-
(1.2) must also be re-positioned.
(3.16) to the material thickness
(2.3)
19 BA-101/3EN M53.XXXX