BLUM MINIPRESS P Manual page 23

7.1 - Error during drilling
Error Cause
Assembly machine is driving against an
object (e.g. swivel stop)
Feed switch was released before the
drilling depth was reached
Work top height (thickness)
Cam brake set too high
Drillings are off centre The swivel stops were not set properly
or in the wrong posi- on the ruler.
tion
Ruler not set properly
Chips between the ruler and the work
piece
Extension ruler is not attached properly
Swivel gear not engaged
Work piece is not positioned on laser
marking line
Work piece cannot be positioned
on the laser marking line
7 - Troubleshooting
Solution
Remove object
Keep feed switch engaged until the drilling
depth has been reached
Put work top underneath until a height of 24
mm has been reached
Open restrictor valve slightly
Check positions and stops and correct if
necessary
Set ruler to the 0 point
Remove dirt and chips
Check ruler attachments and extension -
check spacing of both rulers
Allow index bolts to engage
Position work piece correctly
See following work steps
Adjusting laser to zero marking line:
• Slightly loosen sub-assembly screw using a wrench (counter-
clockwise)
• Set laser line to the zero position
• Tighten screws using wrench (clockwise)
23
Comment
none
none
See chapter 8 - Ap-
pendix
See point 3.1.9
none
See point 1.1.3
none
none
See point 3.1.3
none
none
BA-101/3EN M53.XXXX