Assembly; Cruciform Mounting Plate Assembly; 1) Required Parts; 2) Setting Drill Bit Length - BLUM MINIPRESS P Manual

4.2 4.1 3.3 3.3
4.1 4.2
3.3
3.3 4.1
Ø 5 Ø 5
3.3
3.6
4.3
16mm

4 - Assembly

4.1 - Cruciform mounting plate assembly

4.1.1) Required parts

• Drill bits:
3.3
1 x ø5 mm clockwise
1 x ø5 mm counterclockwise
• Cover caps
• Cabinet Side
• Cruciform mounting plate with system screws
4.1.2) Setting drill bit length (see point 3.1.2)

4.1.3) Setting drilling pattern

• Pull drilling head fixing knob (3.5).
• At the same time, move the lever
• Release drilling head fixing knob (3.5).
4.2
4.1.4) Installing drill bits into the chuck (see point 3.1.4)
4.1.5) Checking drilling depth setting (see points 3.1.5 / 3.1.6)
4.1.6) Setting the cam speed (see points 3.1.7 / 3.1.8 / 3.1.9)

4.1.7) Setting the stop system

• Set the desired dimension using the hand wheel
• or set the stop system to SY using this fixed setting (the drilling distance is 37 mm)

4.1.8) Setting swivel stops

a) If the bottom edge of the door should be flush with the bottom edge of the cabinet,
only the base ruler
Repositioning the ruler:
• Loosen screws
• Move ruler 16 mm in the direction of the outside drill bit
• Secure screws
IMPORTANT:
!
This step will align the 0 point offset for the cruciform mounting plate.
(See point 4.1.8)
(4.1) (marked in black)
(4.2) (marked in red)
(3.3)
(3.6) to the "Hole Group" symbol
(1.7)
(1.2) needs to be re-positioned.
18
(4.3)
BA-101/3EN M53.XXXX