6) Drilling Depth Stop; 7) Setting Cam Speed; 8) Checking Cam Brake; 9) Setting Cam Brake - BLUM MINIPRESS P Manual

3.12
3.11
3.13
2.1
2.2
3.14
3 - Assembly

3.1.6) Drilling depth stop

Another option to maintain a constant drilling depth is to install the drilling depth stop.
When the drilling depth stop is installed, the drilling depth is always 13 mm regardless
of the thickness of the work piece.
Installing the drilling depth stop:
• Main switch at Pos.0
• Remove drill
• Push drilling depth stop into the locking holes of the retainer ring
gages and turn 90 degrees with force.
• Attach drill bit
IMPORTANT:
The drill bit length must be set to 57 mm. (See point 3.1.2). The knurled
!
screw should not engage before the drilling depth is reached. (See point
3.1.5)

3.1.7) Setting cam speed

The cam speed is set via a knurled head screw
• Faster: Turn screw (3.13)
• Slower: Turn screw (3.13)

3.1.8) Checking cam brake

The cam brake slows down the cam speed just before the drill enters the wood. (This
extends the life of the drill and ensures tear-free drilling)
• Main switch (2.1) at Pos. 0
• Keep the assembly machine's work area (A) free.
• Press the feed switch (2.2)

3.1.9) Setting cam brake

The brake is set by turning the screw
• Hard wood: Turn screw
Drill cam will brake harder.
• Soft wood: Turn screw (3.14)
Drill cam will brake less.

3.1.10) Setting the stop system

• Set the desired dimension using the hand wheel
• or set the stop system to the FH using this fixed setting (the drilling distance is 22.5
mm)
15
(3.11)
(3.13)
to the left
to the right
and observe the cam movement.
(3.14) on the cylinder.
(3.14) to the right:
to the left:
(3.12) until it en-
on the back of the cylinder.
BA-101/3EN M53.XXXX