Assembly; Furniture Hinge Assembly; 1) Required Parts; 2) Setting Drill Bit Length - BLUM MINIPRESS P Manual

3.2 3.1 3.2
3.6
3.5
3.7
3.3
3.2 3.1 3.2
3.1
3.2
3.3
Ø 8 Ø 35 Ø 8
3.10

3 - Assembly

3.1 - Furniture hinge assembly

3.4

3.1.1) Required parts

• Drill bits:
1x ø 35 mm clockwise
3.3
2x ø 8 mm counterclockwise
• Cover caps
• Insertion ram MZM.00XX
for the respective furniture hinge)
• Furniture hinge

3.1.2) Setting drill bit length

• The total length of the drill bits (from bit-tip to adjustment screw)
should be 57 mm
• To correct drill bit length, adjust screw accordingly using a screwdriver
Important:
!
All drill bits must be the same length

3.1.3) Setting drilling pattern

• Pull out drilling head fixing knob
• At the same time, move the lever
• Release drilling head fixing knob

3.1.4) Inserting drill bits

• Main switch
• Push drill bits all the way into the chuck (The surface of the drill shaft must be placed
in the direction of the fixing screw)
3.2
• Use a hex wrench to tighten the fixing screws
• Insert cover caps into the unused chucks (3.3). This will keep the chucks clean and
prevent the fixing screws from coming out on their own.
Important:
!
Do not unscrew completely from the drill chuck.
Complete unscrewing could damage the chuck.

3.1.5) Setting drilling depth

• Set drilling depth using the knurled screw
(One turn equals 1.5 mm)
• Secure the knurled screw
(3.1) (marked in black)
(3.2) (marked in red)
(3.3)
(3.4) (see catalogue to determine the proper insertion ram
(3.5)
(3.6) to the "Furniture hinge" symbol
(3.5)
(2.1) at Pos. 0
(3.10) (lock)
14
(3.10)
BA-101/3EN M53.XXXX
(3.7)