Changing The Water In The Boiler; Filter-Holders - Faema Teorema Manual

When the machine is blocked, a warning message appears
on the display: if the key corresponding to the requested wash
cycle is pressed (key
are followed, the wash cycle is performed and the machine is
no longer blocked.
For example, if there is a "coffee block", the following message
appears on the display:
EXECUTE WASHING
The number of the "blocked group" blinks on the display and
depends upon the number of machine groups.
approximately 5 seconds.
The following message will be displayed: "WATER CHANGE".
The water from the boiler will drain from the hot water nozzle
(10) (60 - 70% ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal
1
Put a liter of cold water in a
suitable container and add
detergent.
4
Remove any residue with a sponge and rinse well with cold water.
) and the instructions on the display
) pressed down for
Block function
If the coffee wash circuit key
message will be integrated as shown:
When the "INSERT FILTER HOLDER - GROUP 1" message
appears, the block message for Group 1 disappears. The block
messages for groups still to be washed appear in alternation.
At this point, follow the steps on the previous pages for the
wash cycle.
5
anchoring spring (
15 EN
( ) is pressed, the previous
EXECUTE WASHING
INSERT FILTER HOLDER
GROUP 1
1 2
1 2
holders in this solution for
about 2 hours.
10