Martin MAC Allure Wash PC User Manual page 9

Battery power
The MAC Allure Wash PC's onboard battery gives access to the most important functions in the control
panel when the fixture is not connected to AC power. The following functions are available on battery power:
• DMX address
• DMX control mode (Basic/Extended)
• Fixture ID
• All personality settings (pan/tilt, cooling, fan clean mode, dimming curve, DMX reset, parameter shortcuts,
all display settings, error mode)
• Default settings
• Information (Power On Hours and Power Cycles counters, Software version)
• Error list
To activate the display when the fixture is not connected to power, press the Menu button C. Press again to
enter the menus. The display extinguishes after 10 seconds with no user input and the control panel is
de-activated after 1 minute with no user input. Press the Menu button C again to re-activate.
Shortcuts
If you hold the Menu button C pressed in for 2 - 3 seconds, a shortcut menu with the most important
commands appears. Select a command with the Up and Down buttons D and press the Enter button E to
activate, or press the Menu button C again to cancel.
• RESET ALL resets the whole fixture
• ROTATE DISPLAY rotates the MAC Allure Wash PC display 180°.
Settings stored permanently
The following settings are stored permanently in the fixture memory and are not affected by powering the
MAC Allure Wash PC off and on or by updating the fixture software:
• DMX address
• DMX control mode (Basic/Extended)
• Fixture ID
• All personality settings (pan/tilt, cooling, dimming curve, DMX reset, parameter shortcuts, all display
settings, error mode, etc.)
• Resettable counters
• Service settings (adjustment, calibration)
These settings can be returned to factory defaults using the control menus or via DMX.
Service mode
Holding the Menu and Enter buttons C and E both pressed in while powering the fixture on puts the fixture
into service mode, in which pan and tilt are disabled and a SERV warning appears in the display. Service
mode removes the risk of unexpected head movement during service adjustments.
Cycling power and allowing the fixture to start normally takes it out of service mode.
Control panel 9